Did F*ords use CV front D-Shafts? Homebrew CV?

Discussion in 'The Garage' started by dhdescender, Aug 4, 2003.

  1. dhdescender

    dhdescender 1/2 ton status

    Aug 10, 2002
    Likes Received:
    Qualicum Beach, British Columbia, Canada - Eh.
    Wondering if the 32spline output found on a F*ord 205 is CV flange, or Yoke only?

    If its a CV...could I, in theory, put the flange on my 32spline rear output (TH400 205), retube the front 1 ton ford shaft to work in the rear, and run a homebrew shaft until my funds allow for a High angle driveline CV rear?

    I dont blow U joints in the back currently...so. I dont see it being increased?

Share This Page