FS: 78 jimmy/short pick-up roller

Discussion in 'Pacific Region' started by thor, Apr 26, 2005.

  1. thor

    thor 1/2 ton status

    Aug 20, 2003
    Likes Received:
    To fund my next project I'm considering selling off my rig as a roller (I wanna keep my 454) or parting out if I can get rid of a lot at once. I can also put in a 350 or your motor reasonably. specs are

    78 jimmy with 79 C-10 cab, 113" wheel base, shortened stepside bed with alum floor, show bar, Heavey bumpers with recovery points, tilt column, rear slider (some rash on body) 30 gall tank with skid. hurculined interior.
    * >90% 42/15/15 Swampers, siped, on chrome wheels (some rash on tires)
    * 14BFF, 4.88s, Detroit, blue torch cover, SKY disk brackets.
    * D44 front, YUKON 4340s in & out, YUKON/JANTZ super joints, 4.88s, powertrax, flat-tops, new ball joints, spare set of inners.
    *Both f&r were gone thru with all new bearings, gears and lockers last fall.
    *good working 465/205 raised up nearly flat, also have spare pair.
    *SKY cross over, hydro assist w/ cooler, new tie rod + spare
    *Springs: 52"s up front 3/8" shackles, all 9/16" hardware, 56"s rear with shackle flip, rear shocks relocated to a crossmember.
    *Denney's rear cv driveshaft
    *Front Line-Lock
    *also have tube/stinger front bumper with 8274 mount not shown
    $3,500.00 (probably too much but I don't mind keeping it)

    It's not this clean anymore:
    Lame pose, but shows some flex:
    Last edited: Apr 27, 2005

Share This Page