Dismiss Notice

Welcome To CK5!

Registering is free and easy! Hope to see you on the forums soon.

Score a FREE t-shirt and membership sticker when you sign up for a Premium Membership and choose the recurring plan.

I need a rear driveshaft measurement please

Discussion in 'The Garage' started by gotmud77, Feb 7, 2005.

  1. gotmud77

    gotmud77 1/2 ton status

    Joined:
    Aug 4, 2003
    Posts:
    689
    Likes Received:
    0
    Location:
    bellefonte
    I am changing over to a 465-205 combo and i was wondering if somebody could measure there rear shaft for me.

    I have a four inch lift. Shackle flip in the back and a 14 bolt.

    I am sure somebody is running this same setup.
     
  2. gotmud77

    gotmud77 1/2 ton status

    Joined:
    Aug 4, 2003
    Posts:
    689
    Likes Received:
    0
    Location:
    bellefonte
  3. jones

    jones 1/2 ton status

    Joined:
    May 17, 2004
    Posts:
    379
    Likes Received:
    0
    Location:
    IONIA,MI USA
    465/205 w/ 14bff,no lift=67in. installed.hope that gets you started...it's on a long bed.good luck!
     
  4. gotmud77

    gotmud77 1/2 ton status

    Joined:
    Aug 4, 2003
    Posts:
    689
    Likes Received:
    0
    Location:
    bellefonte
    i need the measurment for a k5 blazer. but thanks for posting anyways.
     
  5. spoolnaround

    spoolnaround 1/2 ton status

    Joined:
    Apr 8, 2002
    Posts:
    1,419
    Likes Received:
    0
    Location:
    Kingsburg Ca
    Mine is 40 1/2" but I have 57" Ferd springs that have had hve been re-drilled 2" back.

    This set up is in my 74 K5 350/465/205/14ff
     

Share This Page