Dismiss Notice

Welcome To CK5!

Registering is free and easy! Hope to see you on the forums soon.

Score a FREE t-shirt and membership sticker when you sign up for a Premium Membership and choose the recurring plan.

Relpaceing DANA 60 seals in a 1998 Dodge 3500?

Discussion in '1973-1991 K5 Blazer | Truck | Suburban' started by fortcollinsram, May 8, 2002.

  1. fortcollinsram

    fortcollinsram 1/2 ton status

    Joined:
    Nov 8, 2001
    Posts:
    2,261
    Likes Received:
    0
    Location:
    Fort Collins, CO
    My roommate and I replaced his pads/rotors last week and when we pull the hubs off, the axleshaft came with it...We tried to use care when puitting the shafts back in but I guess we knicked the seals b/c both sides of the axle are leaking...It generally drips slowly down the inside of the tire then will start dripping to the ground... I have almost no knowledge as to the inner-wrokings of this axle..I believe it has an intermediate shaft that turns in four-wheel-drive and the outer/stub shafts always spin...Can somebody please shed some light on how to go about replacing these seals...

    Thanks...

    Chris
     
  2. fortcollinsram

    fortcollinsram 1/2 ton status

    Joined:
    Nov 8, 2001
    Posts:
    2,261
    Likes Received:
    0
    Location:
    Fort Collins, CO
    Anybody? TTT
     

Share This Page