Dismiss Notice

Welcome To CK5!

Registering is free and easy! Hope to see you on the forums soon.

Score a FREE t-shirt and membership sticker when you sign up for a Premium Membership and choose the recurring plan.

Some shaft help needed

Discussion in '1973-1991 K5 Blazer | Truck | Suburban' started by BLZN4FN, Mar 31, 2003.

  1. BLZN4FN

    BLZN4FN 1/2 ton status

    Joined:
    Dec 19, 2000
    Posts:
    1,720
    Likes Received:
    1
    Location:
    Englewood Colorado
    Ok here is the specs 88 K5 6 inch ft springs. Rear ORD
    4 inch flip 2.5 rear springs. Here goes the questions I got a
    angle finder to find angles and here they are
    (REAR) on the yoke of the 14FF is 21 degrees middle of the shaft is 20 degrees bottom of the slip yoke is 10 degrees is the good or bad?
    (FROUNT) top of cv 0 degrees middle of the shaft 15 degrees
    ft yoke is 10 degrees are these good angles or bad??
    I know everyone talks about the 1310/1350 u-joint but the one from my 10 bolt sure fits real nice in the FF yoke what am I missing here.
    Thanks for any input,

    Bo
     
  2. BLZN4FN

    BLZN4FN 1/2 ton status

    Joined:
    Dec 19, 2000
    Posts:
    1,720
    Likes Received:
    1
    Location:
    Englewood Colorado
    Help someone please help /forums/images/graemlins/cool.gif
     
  3. BLZN4FN

    BLZN4FN 1/2 ton status

    Joined:
    Dec 19, 2000
    Posts:
    1,720
    Likes Received:
    1
    Location:
    Englewood Colorado

Share This Page