Dismiss Notice

Welcome To CK5!

Registering is free and easy! Hope to see you on the forums soon.

Score a FREE t-shirt and membership sticker when you sign up for a Premium Membership and choose the recurring plan.

Where to tap in for oil pressure guage

Discussion in '1982-Present GM Diesel' started by tRustyK5, Feb 11, 2003.

  1. tRustyK5

    tRustyK5 Big meanie Staff Member Super Moderator GMOTM Winner Author

    Joined:
    Jul 23, 2000
    Posts:
    36,166
    Likes Received:
    1,364
    Location:
    E-town baby!
    Where is a good place to tap into on the 6.2 for a mechanical oil pressure guage? All 3 guages in the factory cluster either don't work or are suspect and I'd like to have guages again!

    Rene
     
  2. BlackDog714

    BlackDog714 1/2 ton status

    Joined:
    Jun 8, 2002
    Posts:
    260
    Likes Received:
    0
    Location:
    Indiana
    The factory position is in the valley next to the vacuum pump.
     
  3. JORGE

    JORGE 1/2 ton status

    Joined:
    Jan 10, 2001
    Posts:
    213
    Likes Received:
    0
    Location:
    VITORIA-GAZTEIZ(ALAVA)BASQUE COUNTRY,SPAIN
    I have an Isspro mechnical oil press gauge on my truck.You may to remove the electric sender unit,and screw the tube thread in his place.The sender is in the rear of the engine,under the glow plugs relay,in the bell housing top zone.You can remove it inserting the arm over the tranny/engine union .Is a little hard work ,but don,t worry,i have done it a lot of times.
    Good look. /forums/images/graemlins/wink.gif
     

Share This Page