205 crossmember bushings

[woodchk502]

Looking for some help aka: pics of the tcase crossmember from a 72 with a 350/250 combo. Finally getting around to putting it back in and my bushings are all but gone and I dont know what Im looking for when buying nor do I know where they go when assembled. I guess the most help would be a couple of shots of the pass. side in the vehicle. As always any help would be most appreciated.

thanks jim

 

[Yukon Jack]

Although this is an SM465/Rockwell T221 setup, the mount is the same as the NP205's

There are four bushings, two that you can see, and then two underneath the lower part of the bracket.

If you go to LMC Truck's website, they have a good pic showing the bushings.

 

[bigbadchev84]

http://coloradok5.com/forums/showthread.php?t=266117

Also make sure you dont mix and match your bushings, poly mounts for everything, motor/tranny mount/and transfercase brace. Poly and rubber flex at different rates

 

[woodchk502]

Again guys you save the day. Bigbadchev finally got my adapter to tcasegasket from (from tranny shop) took some doin but got it. thanks. Napa says no go on the bushings how bout online? Any ideas? You guys are awsome. Given the chance bigbadchev im going to buy you a beer..... or ten.
thanks jim.

 

[72blazerguy]

http://www.lmctruck.com/icatalog/cb/t.aspx?Page=50

 

[woodchk502]

funny 72 blazerguy i was on their site as u were posting thanks for the link. though they are poly and I still have rubber engine and tranny mounts

 

[bigbadchev84]

http://67-72chevytrucks.com/vboard/showthread.php?t=303592&highlight=rubber+torque+mount

Looks like they might not be availible.