8274 Trouble please help ASAP

[Elevator Man]

New Motor, new solinoid pack, new controller. I hooked everything up I just mentioned and I only have Power out no power in the relay just clicks. also it is a five pin controller, should it be a 3 pin???

 

[53chevy]

Check your grounding of the motor

 

[53chevy]

http://www.pirate4x4.com/tech/billavista/8274/index.html

 

[Elevator Man]

It has to be in the pack, I swithched the feilds and now it will run in the opossite direction. could one off the solinoids be bad and only one picking?

 

[53chevy]

Make sure everything is tight, it would click on mine when there was something loose and not getting enough current.

 

[Elevator Man]

everything is tight, I took the cover off and checked. The feild wire that hooks to the motor is not getting any voltage on it. I checked it with my meter and I think only one solinoid is picking, arn't two of them suposed to pick. does any one have a picture of a five pin pack, or a simple scamatic?

 

[stallion85]

http://www.pirate4x4.com/tech/billavista/8274/index.html

Did you look at this link? There are electrical trouble shooting steps in it.............

 

[Elevator Man]

That link is for a 3 pin setup Is mine is a 5 pin wouldn't it be different?

 

[Smitty]

That link is for a 3 pin setup Is mine is a 5 pin wouldn't it be different?

Are all 5 pins used? The troubleshooting process should be the same.

 

[Elevator Man]

I'll check it out when it gets daylight!

 

[loafer]

Two solenoids should energize in each dierction.

everything is tight, I took the cover off and checked. The feild wire that hooks to the motor is not getting any voltage on it. I checked it with my meter and I think only one solinoid is picking, arn't two of them suposed to pick. does any one have a picture of a five pin pack, or a simple scamatic?