Anybody know where the crank is in your 2nd gen truck or blazer in relation to the frame? I mean to say is the centerline of the crank higher or lower or centered in the frame up and down ways on the back of the motor.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Crank shaft in relation to frame?
- Thread starter cybrfire
- Start date
84_Chevy_K10
Banned
Mine is sloped 10* downward towards the rear axle.
Now that I think of it, that my not be accurate because I measured on an uphill slope. I'll throw the angle finder on the valve covers in a few minutes. /forums/images/graemlins/thumb.gif
Now that I think of it, that my not be accurate because I measured on an uphill slope. I'll throw the angle finder on the valve covers in a few minutes. /forums/images/graemlins/thumb.gif
backyardbuilt
1/2 ton status
You would think as much as we work on our trucks we would know that off the top of our heads but I can't picture it.
