CA Diy4x engine mounts and ls swap adapter

[K5Luisg]

Diy4x engine mount and ls swap adapters will sell together or split. Installed them in my truck and realized I couldn't use them. No miles on them just install and removal. 100 for mounts 40 for the plates plus shipping cost. PayPal verified located in bakersfield ca. I payed 181 with shipping from diy4x last month.

 

[rompinstompinmudmonkey]

Why couldn't you use them?

 

[K5Luisg]

They didn't set the motor back far enough for my application.

 

[down4thakrown]

Is your drive train in the stock location?

 

[K5Luisg]

It is now with the dirty dingo mounts. The diy4x mounts are just a generic plate ls style system as they call it when I called them with my problem. Suprised more people haven't encountered the same problem I did . I could have used a different plate with the diy4x poly mounts but I was so far into my swap I opted for what I knew would fit and work.
If you plan on doing a rework of drivelines or going with a 4l80 in your ls swap or a combo that's not very common these are a good setup.
If your doing a basic cookie cutter 5.3 or 6.0 with 4l60 and stock t case and stock tcase crossmember go with another setup.

 

[K5Luisg]

This is what the ls bracket for our truck should look like to keep the stock location of Trans and t-case subframe

 

[K5Luisg]

If interested make an offer there collecting dust now just want them gone so I can put the cash toward another project I have going on.