HELLLLP!!!!!!! I am in the middle of rebuilding my NP208, And I'm stuck. There 3 tiny little pices that fell out when I was pulling out the main shaft. I'm pretty sure I know where they go but I can't figure out what holds em in. there are also 2 large round spring clips that may or may not hold em in. Does any one here have an exploded view of a Chevy NP208? or a TSM with an assembly procedure? I have a few diagrams here but none show these 3 pices I'm lookin' for. and to top it off,The diagram that came with my rebuild kit looks different than my actual t-case. It says it's for an NP208 but I think these cases may vary from make to make and application to application. In case you need to know it is a 1987 Chevrolet NP208 mated to an SM465 (granny low 4-speed) Thanks in advance for any help.