New Jegs power steering pump bracket

[Chevy305]

Jegs just came out with this power steering pump bracket and while I have not tried it, it looks stupid simple and easy to install. So to everyone who has the typical squeeling power steering belt problems, this might be a cheap solution for ya:

http://www.jegs.com/i/JEGS-Performance-Products/555/60795/10002/-1?parentProductId=1739308

 

[sweetk30]

junk yard serp belt swap from 90-95 sbc or 4.3 worked for me . 100% bolt on job.

as to that bracket looks like old school bracket just remade from early 70's back style pumps.

old gm tech told me to use a claw hammer for house framing to tighten p/s pumps on v-belt chevys.

install hammer nail puller between pump and bracket and up around bracket like pulling nail. then let head lay on truck frame rial. pull hammer to driver side and it tightens belt good n tight . clamp down bolts and remove hammer.

 

[chulisohombre]

i usually use the pry bar against engine block method to tighten my v belts.works good.just cant over tighten,i did that once and blew the bearings in my alternator.