BrokenBlazer
Newbie
I put in a ff 14 bolt with disk brakes in my 87 Blazer. I can not get any pressure to the rear brakes at all. I am not sure if it is the master cylinder or the power booster or a combination of both. Any ideas would help. Thanks
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
No brakes on disk rearend
- Thread starter BrokenBlazer
- Start date
Xtremegmc80
1/2 ton status
original MC?? did u bleed the brakes? does the brake works in the front?
sta500666
1/2 ton status
Hey I just got done with a swap and rear brakes. I know what the problem is.
Read my posts on this other thread for all the answers: http://coloradok5.com/forums/showthread.php?t=215308
Read my posts on this other thread for all the answers: http://coloradok5.com/forums/showthread.php?t=215308
75k10chevy
Registered Member
Did all the fluid drain out of the master cylinder while you swapped in the axle? If so you might need to bench bleed the MC.
Are the bleed screws on the caliper the highest point in the system (well, the highest point at the axle end)?
They aren't on mine. I have to pull the calipers, use a c-clamp to secure the piston set the caliper up high and then bleed the brakes.
They aren't on mine. I have to pull the calipers, use a c-clamp to secure the piston set the caliper up high and then bleed the brakes.
