Parting out 89 2wd crew cab

[kennyw]

http://www.dol.wa.gov/forms/420040.pdf

Use that bill of sale form if its titled in WA state. It does require notarized signatures from the legal owner (your uncle). Even if you were to try to take this to the dump that form is the minimum required to scrap a vehicle.

 

[1976Blazer76]

whats the length from grille to back of cab, i want to see if it is feasible to put on my buddies trailer.

Back of cab to firewall is about 91" while back of cab to very front is about 138".


Matt

 

[thatK30guy]

Damn. You're so far away. I'd buy the 14FF from you since it should have the extra ribs on the pumpkin.

 

[55Willy]

nice thanks and i'll try to measure my buddies trailer tomorrow. been running the numbers to swap this onto my 1973 chassis with a chopped bed as my tow rig.

 

[1976Blazer76]

If it won't fit, and you really want it, we can work something out....I've got a trailer that can make the trip.

Matt

 

[BigEasy]

PM sent, if you've still got it.

 

[55Willy]

hey matt thanks, but i'll have to pass , if it was going into spring or summer i would but with winter coming i can't get a swap done.

 

[GRINCH]

How about a drivers side armrest?

 

[1976Blazer76]

How about a drivers side armrest?

I think the doors are spoken for, I will let you know.

Matt

 

[uao85]

would you happen to still have the front hanger brackets for the rear springs? would you be willing to seperate them and ship them? zip is 77802. Let me know.

Regards,
Remington

 

[1976Blazer76]

would you happen to still have the front hanger brackets for the rear springs? would you be willing to seperate them and ship them? zip is 77802. Let me know.

Regards,
Remington

They any diffferent than the ones off a 76?

 

[uao85]

They any diffferent than the ones off a 76?

most likely no if its a 1 ton srw. But if it is a 1/2 ton or 3/4 ton then yes they will be different. The spring perch width is different on a srw 1 ton truck vs a 1/2 or 3/4 ton truck/blazer/sub. All of the jyards have crushed their 1 tons as well, let me know.

Remington

 

[1976Blazer76]

most likely no if its a 1 ton srw. But if it is a 1/2 ton or 3/4 ton then yes they will be different. The spring perch width is different on a srw 1 ton truck vs a 1/2 or 3/4 ton truck/blazer/sub. All of the jyards have crushed their 1 tons as well, let me know.

Remington

It's a 3/4 ton, but the sale is pending on the rest of the truck.