rocker idea

Discussion in '1969-1972 K5 Blazer | Truck | Suburban' started by TED, Jan 10, 2003.

  1. TED

    TED Registered Member

    Nov 27, 2002
    Likes Received:
    San Jose, CA
    I replaced my inner/ outer rockers and the floor. The outer rockers that I replaced were rusted form the inside out and I dont want that to happen again. I'm thinking of cutting some 2"x1" holes at the bottom of the inner rockers where they meet the outer rockers in order to allow trapped water and debris to escape. I think I will also use these holes to try to get some POR-15 on the inside of the rockers since I'm sure that most of it burned off when I welded the inner rocker to the outer rocker. Is this a good idea or is there a reason not to that I haven't thought of yet?


Share This Page