shock questions, length and other

[idislikeunc]

87 blazer, 4 inch tuff country front (ez ride) with sway bar disconects, steering correction and brake lines, shackle flip in the rear with stock springs minus the overload.

I will measure once it all goes on, but how much travel can I expect with this setup??

Also, how safe (or retarded) is it to drive the truck with no shocks? If I install the lift at my place and want to drive to the nearest forklift / articulation ramp to measure for shock travel, can I do it??

 

[mrk5]

I think you can find shocks listed for a 4-6" lift, not just straight 4". I think that might be your ticket.

I wouldn't expect more than 9" travel, but that's a guess based on my 52/56 setup that yields 12" total travel.

B_to_C has 12" travel shocks on a similar setup and they are plenty.

 

[cbbr]

Just drive it slowly and go when trafic is light.

 

[fireplug]

If you don't mind my highjacking a bit, short of using a forklift or articulation ramp, any suggestions on flexing out to measure for shocks?

 

[mrk5]

If you have jackstands tall enough, try letting the axle full droop. Best if you can keep the wheels/tires installed because the extra weight will pull the axle down further.