SM465 pressure plate bolts

[Camaronate]

http://www.jegs.com/i/ARP/070/130-2201/10002/-1

Anyone know if this is the bolt set I need to attach the pressure plate to the flywheel on a 6.2l? I think it is correct but I want to confirm before I get them.

Thanks,
Nate

 

[kennyw]

I can't look at your link from work, but I've always used the same bolts that were used on a small block 350 flywheel/pressure plate.

 

[Camaronate]

Which ones are those? I have never owned a manual trans or done a clutch before. I am preparing to swap my 700R4 to the SM465 and have eveything except the bolts to attach the pressure plate to the flywheel. The new flywheel did not come with new bolts.

Nate

 

[kennyw]

I believe they were all standard grade 5 hex head bolts (SAE J429). I don't know the diameter or length off the top of my head though.

 

[tRustyK5]

Those should work, and as well as being a ton stronger than the stock grade 5 bolts those also have a conical compression washer.

Rene

 

[Camaronate]

cool, thank you, will be ordering today. As soon as my back heals this trans is ready to go in.

Nate