Square tube front driveshaft

[thedrip]

Clearing up the side yard.

My square tube front shaft.
S44/1310 hybrid top joint. 1310 shaft side, s44 tcase side w/ flat flange.
1310 Lower ujoint. inner box 2x2x.25", outer tube is Receiver stock .25" wall.

Was used on my blazer (th350/np203), 4" lift with d44, 6" lift with d44, 6" lift with d60, 56" spring swap with d60. With over 12" of slip it will fit pretty much anything.

$80 shipped (its heavy with a capital h-e-a-v-y)

 

[thedrip]

Maybe everyone was afraid of the cost of shipping on such a heavy item? now $80 including shipping.

 

[thedrip]

If you remove the top flange, this is a 1310-1310 driveshaft. $60 shipped anywhere in the us. Half of that is shipping!

 

[rcpd34]

PM sent.

 

[thedrip]

These were all the rage when I built it! Someone out there needs a durable front shaft!

 

[newbie79]

do you happen to know where there is a thread or maybe you have one showing the build of the drive shaft?

 

[thedrip]

Closest thing to a build thread I made was an announcement of completion. I did find an installed picture though.

 

[Deuling]

do you happen to know where there is a thread or maybe you have one showing the build of the drive shaft?

For his price it would probably be cheaper to buy than to build one unless you have all the parts lying around

 

[newbie79]

dont get me wrong I would rather buy his than make mine, I am not that good at welding yet. I just dont have the cash right now, maybe in a week or so, but thanks for the pic. If its still available when I have the cash then I will snatch it up. thanks again
scott

 

[Robbie6987]

If you still have it ill take it.