merlot566jka
Registered Member
I am looking at getting a rear axle with 3.73s to replace my 3.08s, but its from a 77 chev truck with 6 bolt lugs, and i have 5 bolt lugs.
will it work?
will it work?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Sub and Truck rear axles the same width?
- Thread starter merlot566jka
- Start date
Yep, they're the same width between truck and 'burb. You're putting it on a 2WD? I figured it must be if it's 5lug. If they're both 10B axles then shafts should interchange, unless yours happens to be 88-up, then spline count may not match.
merlot566jka
Registered Member
yup, 2wd 5lug.
its an 86 burb, and as far as I can tell the rear is 100% stock.
its an 86 burb, and as far as I can tell the rear is 100% stock.
Yeah the 77 will have a 12 bolt, yours is a 10 bolt so shafts will not interchange.
Why do you want a 6 lug rear?
Are you getting it to go 3.73 gears?
