Tcase drop and shaft Q

Discussion in 'The Garage' started by TXsizeK5, Oct 7, 2003.

  1. TXsizeK5

    TXsizeK5 1/2 ton status

    Aug 26, 2001
    Likes Received:
    College Station, TX
    Could I take out my t-case drop spacers? Its dropped alot, like over an inch. I can do this and get longer and new double cardon shafts from high angle (right now i have a used tom woods rear double cardon and a stock front that gets bound at full droop)

    This would increase my center clearance a bit and put my tcase between the frame rails more to protect it from getting hit? So i guess my question is, would the driveline geometry be fine if i were to get longer shafts and put the tcase back to stock position or maybe safer up?

Share This Page