CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Turbo 400 disassembly
- Thread starter Kain
- Start date
Kain
3/4 ton status
last few days been slow and steady , those pics above are a few years old. I tossed alot of photos and vids i should have kept
Kain
3/4 ton status
well i think this morning i can put the trans back in and the transfer case..............
You know to replace that, right?
Just asking...
Kain
3/4 ton status
Trans is back in
Kain
3/4 ton status
Do these mean anything?
And I did not know that
And I did not know that
Maybe numbers TCI stamped in to identify the case?
Kain
3/4 ton status
Na we took it to B&M transmission out of Las Vegas and took the kit to em and the my just put it in
Huh? Isn’t it a TCI trans?
It's the VIN. First digit "1" = Chevy.
Kain
3/4 ton status
We had a Tci master rebuild kit in it
Last edited:
Kain
3/4 ton status
transmission, transfer case and cross-member are back in.
Then I started getting dark clouds rolling in so ill have to Finnish tomorrow
Then I started getting dark clouds rolling in so ill have to Finnish tomorrow
Ahhhh gotcha
Kain
3/4 ton status
I changed the drivers side motor mount it tore. And now there is half an inch clearance between frame and balancer . Pic below
I don’t think it’s supposed to be that way. Torque converter bolts and fluid and I’ll have her running again
I don’t think it’s supposed to be that way. Torque converter bolts and fluid and I’ll have her running again
Kain
3/4 ton status
And see if I did a good job or waisted my time……
I was shocked how much higher my engine set after replacing the mounts.
Kain
3/4 ton status
the passanger was not tore but i will change it eventually
for some reason i got sick at my stomach and layed down
didnt mean to sleep 4 hours but i did
for some reason i got sick at my stomach and layed down
didnt mean to sleep 4 hours but i did
Kain
3/4 ton status
HOW IN THE HELL DOES THIS HAPPEN?
I was putting Trans fluid in and I spilled some on the header.
Smoke galore, so I look down and saw a wet spot touched and sniffed it FUEL LEAK!! The thing was spraying on the winch controller.
Guess the good lord was watching and I didn’t catch it on fire . I am done till morning
On a plus side after not running for months it fired right up and idled like a big dog and no funny noises on start up from the trans
I was putting Trans fluid in and I spilled some on the header.
Smoke galore, so I look down and saw a wet spot touched and sniffed it FUEL LEAK!! The thing was spraying on the winch controller.
Guess the good lord was watching and I didn’t catch it on fire . I am done till morning
On a plus side after not running for months it fired right up and idled like a big dog and no funny noises on start up from the trans
Last edited:
Kain
3/4 ton status
Well i cut and redid the line to see if i could get it to sop leaking and i have to replace the entire line. I have it just spent 30 min looking for it.
on a plus when it was cold i fired it up and put into gear and it engaged. I don't know how it will act when i fix the fuel leak but that is a plus .
on a plus when it was cold i fired it up and put into gear and it engaged. I don't know how it will act when i fix the fuel leak but that is a plus .
Inline tube. Which line are you looking for?
