Discussion in 'Parts & Trucks Wanted' started by TopOff, Dec 6, 2003.
LMK what you got. I prefer thick flanged stuff...
Got three of em /forums/images/graemlins/grin.gif. Pass side got in a fight with a D60 pumpkin and lost /forums/images/graemlins/grin.gif You can mave em all for 50 plus shipping. If you have anything you want to get ride of, maybe that's something I've been looking for /forums/images/graemlins/rotfl.gif
I just need one good one.
How are the flanges? I am hoping for some good flanged units.
Shipping to 95630?
Not quite sure what you mean ny the flanges being good. could you describe? Thanks,
The flange being the thick piece that bolts to the actual head of the engine. Sometimes the cheaper units are only 1/4" thick. If they are only 1/4" they tend to blow gaskets.
The matched set I have are Hedman Headers. I measured the flange you spoke of & it was 1/4 inch. I guess that means you aren't interested.
Depends on how much and shipping.
Make me an offer I can't refuse /forums/images/graemlins/grin.gif
SHipping would be from 80925
I have no idea what they go for.
I think shipping would hurt. I don't know how much they weigh or their size or anything.
95630.. LMK! /forums/images/graemlins/ears.gif
Let me get an approx weight for a price. Then you can decide.
BTW, How about $9. Then I can get at least a decent six pack /forums/images/graemlins/grin.gif
$9 sounds promising.... /forums/images/graemlins/rotfl.gif
You got 'em?
Anyone else have an intake for a BBC?
Prefer something besides Edelbrock.. But an Edelbrock for a good price will do too.
I've got a factory iron Q-jet intake. Free to anyone that wants to pay shipping for it. /forums/images/graemlins/eek.gif It weighs pretty close to 50 lbs. /forums/images/graemlins/shocked.gif
Thanks for the offer. /forums/images/graemlins/thumb.gif
But, I more interested in an aftermarket aluminum one.
Can't say that I blame ya! This one is probably gonna end up on the scrap heap, 'cause I need the shelf space back. /forums/images/graemlins/frown.gif
So, does that mean you'll take the headers for $9 plus shipping? If so, reply with your zip & I'll try to get it done this week. If it is ok with you, I'd rather ship after the holidays due to the crowds. Let me know. Either way, I'll get it packaged up.
Anybody have an estimate for weight of a set of headers?
My zip was up above.. but
I was kinda' hopin' before the holidays. But the way the motor build-up is going, I won't have it done until next year. /forums/images/graemlins/frown.gif
I am still interested. I am looking to get this running in 1 - 2 weeks.
I'll try to get weighed, but time is pretty tight right now. I've been busting my butt trying to get a little ahead so I can have some time off around the holidays. Not looking like that;s gona happen regardless. ANyway, I will do my best to get these weighed and shipped. If it works for you, I'll just ship them and PM you with the cost & you can add the $9 and mail me a check. If this';ll work for you, PM me your address.
I found a box on Sunday and I went to pack up to get weight. I noticed the right (pumpkin side) header is smashed pretty good. That is why the previous owner had to replace that side once. Too much stuffin'!! Anyway, let me know if you still want before I get boxed up.
PS - Sorry I didn't notice earlier!!!
Separate names with a comma.