What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

'04 Tundra DD/CC/6" lift/35s/OBA.... [Tire carnage...]

spongeidys said:
sadly... theres not that much room in the 4runner for this tank as is.. hah..
Click to expand...
I can't fit a 35" spare;
So, I removed the spare tire, and spare tire retainment mechanism.

Now the whole rear x-member is open, frame rail to framerail. :D

Gotta love a Double-Cab... :thumb:
 
my 35" spare takes up almost the entire back of the 4runner.. i can barely fit a small tool box with it.. i need to build a mount to get it upright but its hard to do without a welder..

and ive been looking underneath for a place to put the tank its just everywhere i find im worried itll get ripped off by a rock
 
spongeidys said:
my 35" spare takes up almost the entire back of the 4runner.. i can barely fit a small tool box with it.. i need to build a mount to get it upright but its hard to do without a welder..

and ive been looking underneath for a place to put the tank its just everywhere i find im worried itll get ripped off by a rock
Click to expand...

I'd be worried, too...

This truck is a pavement princess, that see's sand 2-5x a year.
No worries about the rocks... :D

The tank does have a TON of ground clearance, tho.
I'd say at least 3 feet. :pimp:
-----------------------------------------------------------

When I do my OBA, in the Blazer, my tank will go in the back.

I removed the rear bench, and will replace it w/ two bucket seats.
The tank will sit horizontally behind the seats, in a steel box.

The box is less for safety, than it is to make it a flat surface.
Should be nice.
 
Last edited:
Just got the orifice valve, from Hornblasters.com :thumb:


They recycle their old sticker-backing. :waytogo:
IMG_7875.jpg



$30 for a 'high flow', 1/4" NPT, Solenoid Valve.....
That's a really good deal, actually. :D
IMG_7876.jpg



It's actually pretty beefy...
IMG_7881.jpg



They even index a line, for repair's sake... :pimp:
IMG_7883.jpg



Time to finish the install... :D
IMG_7885.jpg
 
I'm done!!!! :pimp:


The empty hole is were a dead-switch was.... :doah:
IMG_7887.jpg



Get some!!! :woot:
IMG_7890.jpg



Horn selector switch...
IMG_7891.jpg

---------------------------------------------------------------------

Where I tapped the horn power....
IMG_7897.jpg



I love how simplistic the engine bay is.... :D
IMG_7900.jpg



So nice....
Gotta get some kind of wrap, for the air lines, tho. :thinking:
IMG_7903.jpg



Horn if yer Honky!
IMG_7905.jpg



I'm quite pleased... :thumb:
IMG_7909.jpg

------------------------------------------------------------------

My dual's, taking their morning piss.... :haha:
IMG_7912.jpg

------------------------------------------------------------------
 
I have to go somewhere else to get a video of BLASTING it....

My neighbor's already complained.

I waited till my pita neighbor was halfway into his mini-van;
Then, I blasted the horns.... He almost fell back out.

I almost fell down laughing... :haha:
 
I plan on putting a firetruck air horn on my blazer. I figure if I have OBA why not run a stupid-loud air horn:D Now to install the OBA...
 
You must log in or register to reply here.

Latest Posts

Top Bottom