jumped to the big boys club with a 60, now if i could just get all the parts out of the garage and on the truck
i have a hard time getting to the post office most of the time but i think i can swing shipping a couple things.
10 bolt 28 spline detroit ez locker. brand new. 300 shipped
flat top dana 44 knuckles, stock condition. sold
10 bolt front axle shafts 28 spline. sold
8 lug front hub conversion, all you need is bearings and seals. 100+~25 shipping sold
superduty dual shock towers. 25 shipped
8 lug steelies, 16 inch. 100 for five.
my faithful ten bolt set of axles. im gonna miss these gals. 400.
4.56 with an auburn unit in the rear with 1350 yoke. warn premiums. new bearings and seals on the front. it will come with the stabilizer setup. these are still on my truck, and until i swap em ill be using them.
nothing in this pic is too rusty to use, the rotors probably dont even need turned and the knuckles can just be wire brushed clean. ive had em bare about a year. shafts arent rusty at all.
i have a hard time getting to the post office most of the time but i think i can swing shipping a couple things.
10 bolt 28 spline detroit ez locker. brand new. 300 shipped
flat top dana 44 knuckles, stock condition. sold
10 bolt front axle shafts 28 spline. sold
8 lug front hub conversion, all you need is bearings and seals. 100+~25 shipping sold
superduty dual shock towers. 25 shipped
8 lug steelies, 16 inch. 100 for five.
my faithful ten bolt set of axles. im gonna miss these gals. 400.
4.56 with an auburn unit in the rear with 1350 yoke. warn premiums. new bearings and seals on the front. it will come with the stabilizer setup. these are still on my truck, and until i swap em ill be using them.
nothing in this pic is too rusty to use, the rotors probably dont even need turned and the knuckles can just be wire brushed clean. ive had em bare about a year. shafts arent rusty at all.
Last edited:
