SUBFAN
1/2 ton status
What size hole is required for these? I need to enlarge the hole in my D60 hubs for the disc swap....
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
14FF Wheel studs....
- Thread starter SUBFAN
- Start date
SUBFAN
1/2 ton status
C'mon, who is holding out? Tell me what size drill bit to buy....
You need the diameter of the hole in the 14B hub?
SUBFAN
1/2 ton status
YESD, so I can redrill mine to fit....
Hey, me too /forums/images/graemlins/whistling.gif I know the stud is a 9/16" thread, but might be able to get a hole size off of an old 14FF drum if I didnt scrap them... /forums/images/graemlins/doah.gif
It looks to be about exactly 19/32" maybe start with a 9/16 and see how tight it is. BTW I measured this off of a 14BFF hub soo it should be accurate /forums/images/graemlins/waytogo.gif /forums/images/graemlins/peace.gif
SUBFAN
1/2 ton status
Thanx, one step closer /forums/images/graemlins/waytogo.gif
