1970 Blazer bucket seat mounts and pictures needed.

[tabber]

Hey everyone, just picked up some ratty bucket seats for my Jimmy. Unfortunately some of the brackets to the floor were cut off with a torch,and the quick release floor bracket for the passenger side is missing. Wondering if anyone has some pictures I could see to try and fabricate the damaged pieces. Specificall the passenger side.

Also looking for replacement bucket seat mounts for the driver side, these were torched and rusted severly. I'm in St. Paul if anyone is local. Thanks for any help. JT.

 

[diesel4me]

I think I might have the floor bracket that the passenger seat hold down pin goes into--but no other parts..

 

[dremu]

IIRC, the bracketry is very similar from the 69-72 generation to the 73-75 full verts. I *swear* I have pix somewhere from my '74, but dang if I can find them. I'll try and describe them from memory, see if that helps.

The passenger side has a decidedly phallic knob that comes out of the bottom at the center of back, and there's a lever that pops it in and out. The floor snap is then an inverted U-shaped piece of flat stock, at most 1/8" thick, with a dimpled hole in the center part of the U for that knob. There's then a tab on each side of the U, with a hole for the bolt that holds it down, and a another piece of flat stock underneath straight across with just the two mounting holes. Should be easy to fab, no welding, just bending.

Some Googling found these for you, hope that's a starting point: