sold
Last edited:
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
1973-87/91 Half Doors
- Thread starter kennyw
- Start date
So far shipping quotes via Forward Air have been $260 to Denver and $300 to Toronto.
Chrisblazzer89
1/2 ton status
How much shipped to 02301?
Shipping to the nearest forward air terminal will be in the $300 range.
Chrisblazzer89
1/2 ton status
SO would it be 300 (for shipping) + 350 (for the doors) or just 300 flat out?
$300 is the shipping quote from Forward Air plus the $350 I am asking for the doors. $650 total. Unfortunately these doors are heavier than a stock door 
so shipping them doesn't look good.
so shipping them doesn't look good.
wish you were within a couple hours, id buy them in a second. i dont even wana know what it would cost to ship them all the way across the country
Chrisblazzer89
1/2 ton status
Well i cant get them i dont have 650 to spend on just doors i guess ill just make my own sry
Not a problem... I don't expect anyone to want to spend $300 to ship a pair of doors.
c.r.mason
Registered Member
if still avalable,how much to 57350 by snale
The cheapest I have found for shipping to the east coast has been around $300. Your welcome to shop around for shippers yourself. Just figure 200# total with a 4' X 4' pallet about 2' tall.
c.r.mason
Registered Member
I'll check with fraght co. in phone book next week, if east coast is 300 then arm pit of USA (S.D.)shouldnt be much over 298 (if they can find me)
I was thinking South Carolina looking at your location... I got a quote to Denver for $250 but that was shipping to a forward air terminal. Don't think they have any terminals in South Dakota though.
Looks like Minneapolis or Omaha are the nearest Forward Air terminals to you...
c.r.mason
Registered Member
call me 605-350-0897,snowing sideways now so I should be around
ttt
solidaxlesub
1/2 ton status
looking for anything in trade? I dont have to ship either, im on the east side of the state
I could use a locker or power loc for a 35 spline Dana 60 front axle w/ 4.56 gears. I would do a straight across trade on a locker or a partial trade for the power loc.
Another possibility would be a winch.
Another possibility would be a winch.
ttt
