CO 1984 Tilt Steering Column For Manual Transmission

[Capt Ron]

Good condition, still very tight and turn signal/wiper switch feels/works like it should.
Currently has steering wheel with GMC horn button.
Currently no key but will find one or install new key switch.
$300.00 with wheel, $275.00 without.

 

[obijuank5]

Gahdamn that’s a fair deal. I don’t remember, can you chance the cylinder as easy without having the key?

 

[imiceman44]

Gahdamn that’s a fair deal. I don’t remember, can you chance the cylinder as easy without having the key?

You might be able to but not easily

 

[Capt Ron]

Gahdamn that’s a fair deal. I don’t remember, can you chance the cylinder as easy without having the key?

I have a coffee can full of older Gm keys, have about a 20% success rate with finding a key.
If not I will just buy a new lock and pull the wheel, retainer plate, ts switch and swap a new one in.
Takes me about 25 minutes

 

[Capt Ron]

Gahdamn that’s a fair deal. I don’t remember, can you chance the cylinder as easy without having the key?

About 50 keys into my can I found one.

 

[imiceman44]

About 50 keys into my can I found one.

View attachment 529534

I have about 30 keys

 

[muddybuddy]

How much to ship to 22039? No wheel

 

[Capt Ron]

How much to ship to 22039? No wheel

I think the last one I did about a year ago was close to $65.00 for shipping.
Seems like I had a heck of a time finding a box.
I usually ship without wheel and unbolt the slip shaft to make it a bit shorter and the ts/tilt levers to avoid them getting broken.
Let me find a box and get some shipping quotes.
Any preference on a shipper?

 

[obijuank5]

Last one I shipped I used an axle shaft box and hole saw in a 2x 6x6 squares for top and bottom caps and it seemed to do really well.

 

[sweetk30]

Pull wheel . Pull lock plate . Pull turn signal switch away . Pull bolt and slide out cylinder .

Reverse and good to go .