Jrgunn5150
1/2 ton status
Hey guy's, I'm back selling my half-ton longbox p/u again. Body is rusty, cab and box floor's are good however. looking for 2000 OBO on this one, good project truck, but it won't pass smog for me in California, so it's gotta go.
Here's a list:
355 Basic rebuild here, hyper pistons, cast rods and crank, 882 heads
Comp Cams Xtreme 4x4 cam, the small one, I don't remember the specs at the moment
Edelbrock Performer EPS intake
Holley 670 Truck Avenger Carb
MSD distributor, cap, wires
B&M Holeshot 2200 rpm converter
TCI Truckmaster 700r4
B&M truck mega shifter
Rebuilt NP208
Stock ten bolt's, stock gearing
33 inch Goodyear MTR's, 80%
3" Body lift, stock suspension
Flexsteel bench seat, otherwise stock truck. I have attached photos of all the problem areas, trying to be honest here, but don't think it's a pile because of it. Feel free to contact me here, at [email protected] , or call my cell and leave a message at 231-343-7943 . I'll take you for a test drive, take more photos, or whatever you want. I'm leaving for California again in three weeks, so it's gotta go before I do. Thanks for looking.
Here's a list:
355 Basic rebuild here, hyper pistons, cast rods and crank, 882 heads
Comp Cams Xtreme 4x4 cam, the small one, I don't remember the specs at the moment
Edelbrock Performer EPS intake
Holley 670 Truck Avenger Carb
MSD distributor, cap, wires
B&M Holeshot 2200 rpm converter
TCI Truckmaster 700r4
B&M truck mega shifter
Rebuilt NP208
Stock ten bolt's, stock gearing
33 inch Goodyear MTR's, 80%
3" Body lift, stock suspension
Flexsteel bench seat, otherwise stock truck. I have attached photos of all the problem areas, trying to be honest here, but don't think it's a pile because of it. Feel free to contact me here, at [email protected] , or call my cell and leave a message at 231-343-7943 . I'll take you for a test drive, take more photos, or whatever you want. I'm leaving for California again in three weeks, so it's gotta go before I do. Thanks for looking.
