1989 3/4 GMC BURB roller $650 O.B.O.

[70BlazerX2]

I have a 1989 2wd burb body sitting on a 1980 3/4 4x4 frame. $650 or best offer.

Its titled as an 89 2wd rust free tub, but has a few small dents here and there, nothing bad,worst is on the pass rear quarter by the rear bumper. Loaded gmc sle burb,power windows,locks,front and rear a/c grey interior. It has no motor/no trans/no case/no front driveshaft. Has new support and inner fenders,and grille and headlight doors that have 5,000 miles on them

14 bolt FF rear 10bolt 8.5 corp. front.

Has a 6 inch rough country lift on it ,with shocks and arm.
Lift has about 5,000 miles on it. The lift cost me 600.

I am located in greeneville tennessee 37745 is the zip.

Tire are good only for rolling around. I had 35's on it.

Comes with rear driveshaft. Was a th400/205

which i have it for sale or here for $300 on the trans/case board

 

[70BlazerX2]

I will part it out soon if if does not sell. I am interesten in a 81-87 short bed chevy or gmc truck...basicly i need a frame with a cab and title. 2 or 4 wheel drive. I can put these 3/4 ton rears and trans/case ect into. I have a great 350 to put in one also.

I may even use a 81-91 fullsize blazer/jimmy frame with a pickup cab..you get the idea..the burb is just to big

This also has the 40 gallon gas tank option.

This is a nice 89-91 upgrade front to any 81-87 truck

 

[Mr.Chevy4x4]

What gear ratio is in the axles?

 

[70BlazerX2]

I will have to pull a cover and check and post back here tonight,Thanks

What gear ratio is in the axles?

 

[35dp]

any chance you would deliver or meet me halfway? mapquest says 450 miles.

 

[70BlazerX2]

any chance you would deliver or meet me halfway? mapquest says 450 miles.

I can meet you somewhere just east of nashville on I 40 for the $650 and $40 for gas. It will be about 2 weeks before i can do this,i have to change the gears in my rollback to do so.If this is ok,post here 1st, then pm me,Thanks

 

[70BlazerX2]

Bump To The Top ask away..