CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
1989 engine
- Thread starter Ed-Mann
- Start date
700r4 shouldn't be a problem as most of those trucks had the 4L60E behind the Vortec which is a a computer/electronic controlled 700R4.
gm still uses same bolt pattern for bell housing . even the ls series motors with minor bolt hole moved for water jacket in block .
and 96 vortec block will bolt in no problems . just use all your original mounts to your current frame.
and 96 vortec block will bolt in no problems . just use all your original mounts to your current frame.
Officer_sloppyjoe
Registered Member
I have done this swap on my 89 GMC Jimmy and it will swap.
That's a good thing about GM blocks is that there is not a lot of bellhousing variation so there are a lot of potential engine/transmission combinations.
1989
good i was hopeing to hear that sorry i took so long to get back i just got the 700r rebuilt and did not want to have to replace it right after i got all that work. done plus i did not want the down time of haveing to take the engine out to do the work on then put back in. should =not have to worry about the torque converter eirther then too.
good i was hopeing to hear that sorry i took so long to get back i just got the 700r rebuilt and did not want to have to replace it right after i got all that work. done plus i did not want the down time of haveing to take the engine out to do the work on then put back in. should =not have to worry about the torque converter eirther then too.
