1989 Suburban ft rocker pannels wanted ?

[Delaware4x4]

both our outter front rocker pannels/below front doors are rusted/
looking for a NEW set to mig weld in..any known supplyers ?
how hard to mig them in?

 

[sweetk30]

most any place as these parts are only made by a few makers if that many. just get diffrent stickers on them.

be prepared to work them a little as not bolt in/weld in ready .

i just did cab corners and had to rework the backsides a bit.

but measure 2-3 times and mark out a hair big and cut off . then drill out spot welds . clean prep behind and then test fit and work till happy and then weld them in by working all over not 1 huge weld in a small area or major warping will happen.