1st gen jimmy rear seat mounting hardware

[Cadden]

Here are a couple of pictures of my LMC tank with the stock neck brazed on and the 3/8 line leaving the sender/pickup unit and heading up the frame. The lines with the blue caps are the 5/16 line
for the evacuator canister.
View attachment 354957
View attachment 354958

Thanks for those, thats exactly what I needed to see. So the 3 lines on the filler side go to the canister, which I also don't have. Lol

 

[joedragrace]

Thanks for those, thats exactly what I needed to see. So the 3 lines on the filler side go to the canister, which I also don't have. Lol

The 3 lines on the filler/driver side go to the (not sure what it's called) maybe a vapor chamber. The single line on the passenger side runs to the front where the canister is located.

 

[Cadden]

The 3 lines on the filler/driver side go to the (not sure what it's called) maybe a vapor chamber. The single line on the passenger side runs to the front where the canister is located.
View attachment 355016 View attachment 355018 View attachment 355019

Hmm mine doesn't have the extra tube next to the filler neck like yours

 

[Cadden]

I've got good pedal play and adjustment. I've got the tunnel off watching the fork. I'm thinking back months ago to using red thread locker on the bolts and maybe using a bit to much and it dropping down on the flywheel. And its been sitting some time since i put the transmission and new clutch in

 

[Cadden]

I think my seat uses carriage bolts like the ones in your floor. The front of my seat just has a bar 'foot' so I added a small U bolt (drilled two holes in the floor) to hold down the front of the seat as well.

Here's the front bracket for that rear seat bar I found online btw

 

[Burt4x4]

Here's the front bracket for that rear seat bar I found online btw

View attachment 358947

Nice!
Wish I had the power of the internet when I started working on my K5 in 1993

 

[Cadden]

Nice!
Wish I had the power of the internet when I started working on my K5 in 1993

I wish the people who owned this jimmy before me did as well cause they welded a bar of some sort on the front leg bars so I can't use these now lol

 

[Burt4x4]

Dang IT! Well fab your way around it