20* steel axle shims, made by muddytazz. never installed, going another route.
$50 + shipping
$50 + shipping
Last edited:
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
20* axle shims *PICS*
- Thread starter muddybuddy
- Start date
make offer!
Can you send me a pic?
$30 including shipping to Michigan?
ill get pics. id need more than $30. i paid $85 for them, and they have never been installed.
i will also include 2 4" leaf spring pins, never used as well.
yup haha. with the price of steel now, they werent cheap 
muddybuddy said:
Holly **** are those ever huge.
K, those are a lot bigger than I was picturing.
Going to have to pass.
Regards
Ryan
fright98
Registered Member
did you sell your shims?
nope still got them. want them? 
fright98
Registered Member
yes. pm me. i will give them a try.
pm sent
chopped&bobbed77burb
1/2 ton status
Holy Crap thats a shim ? I thought it was a splitting maul for splitting fire wood 
. I guess it's the cheaper mode then turning your knuckles 
. Good luck with those .
. I guess it's the cheaper mode then turning your knuckles . Good luck with those .
MattK
1/2 ton status
you sure those aren't oil ramps?
lol jp, but seriously...what kind of lift would call for 20* of correction?
lol jp, but seriously...what kind of lift would call for 20* of correction?
chevyin
1/2 ton status
X2 on the how much lift?
well i never put them on, but it was going to be on a k5 with 10" lift. i think they are actually 18* shims. i didnt have a welder or i would jus rotate the perches. i bought them jus to get rid of the nasty noise of driveshaft binding so i could sell the truck, but ended up not needing to sell it so i never installed them. could prolly make a couple sets of 5* and 8* shims out of them if you had the right tools.
top...could easily make a couple pairs out of shiims out of these! steel aint cheap
back from the dead. dont know if ive still got the centering pins, but will take $40 + shipping.
you could easily cut them down and make 2 or 3 pairs of shims out of these! with the price of steel now this is cheap! or sharpen and use them to split wood with a maul!
you could easily cut them down and make 2 or 3 pairs of shims out of these! with the price of steel now this is cheap! or sharpen and use them to split wood with a maul!
