203 adaptor

[RGV72BLAZER]

i have a th350/203 adaptor that i'll be using. i was wondering if the seal on the adaptor could be replaced, as the one currently on it is beginning to tear off. any part #'s if they're available? i went to autozone this past weekend and the guy looked at me blankly and said they didn't carry it without looking it up or even trying to help me in some other way. i even tried asking him again and told me no shaking his head before i could even finish...yea great customer service.

 

[4X4HIGH]

Are you talking about the O-ring on the tranny side? Other than that there is no seal that i'm aware of. I have one sitting in the garage and no seal whatsoever. The seal for the 203 is in an aluminum plate that bolts to the 203 case.

 

[littlejimmythatcould]

I had to try several different size O-rings until I found one that fit. If you are talking about the gasket, I cut my own out of a roll of felt gasket material and marked the holes and used a hole punch to punch the holes where the bolts go. Hope this helps.

 

[RGV72BLAZER]

i'll try to get a pic this weekend. it looks like a rubber seal/oring. thanks guys.