32 spline NP205

[85 Jimmy]

I can't find any in the local yards. Anyone near the gulfcoast have a 205 they want to get rid of? Or does anyone have one that they'll let go cheap enough to make up for shipping it?

 

[sweetk30]

short input 32 for fig 8 style

or

long input 32 spline for round 6 style.

good luck tho . i dont have any at this time.

 

[85 Jimmy]

It's for a doubler, so that would be figure 8 iirc.
And I don't need just the input, I need a whole t-case.

 

[sweetk30]

you can use both style cases but just need the shrt input gear from a fig 8 style basicly.

so if you find somthing its easy to make it work.

and if you have or find a 27 spline 205 you can bore out the case and buy a gear from vendors like ord to make it 32 spline.

 

[GreenieK30]

Your best bet would be to find a local machine shop to bore out the bearing hole and get a gear, bearing and retainer clips from an online vendor. I have the complete case you are looking for but shipping would probably be a deal killer.

 

[85 Jimmy]

Your best bet would be to find a local machine shop to bore out the bearing hole and get a gear, bearing and retainer clips from an online vendor. I have the complete case you are looking for but shipping would probably be a deal killer.

The problem is I can't any NP205 for sale. Atleast not on my local forum, junkyard, or craigslist. I lucked out and found a 203, but I haven't had any luck with a 205.

Or I should say I can't find a NP205 for sale locally.

 

[GreenieK30]

I would sell mine for $400, you arrange shipping from Fife 98424 or Tacoma 98412. The case is a 11-79, short input, figure 8, 30 spline front driveline output, 1350 fixed rear yoke, takeout. I would sell a stock 10 spline complete case for $100 which would be a good core to have machined for the 32 spline input.

 

[85 Jimmy]

I'll keep looking alittle closer for awhile. If I can't find anything I'll let you know.