465 pedal rod (wrenching right now)

Discussion in 'The Garage' started by AussieK5, Sep 18, 2005.

  1. AussieK5

    AussieK5 1/2 ton status

    Jun 17, 2001
    Likes Received:
    A land girt by sea
    I was changing all the cab mounts on my K20 and pushed my luck too far jacking up the RH side of the cab and I think I tweaked the 'pedal to clutch rod' on my 465 :doah: . ... I now have clutch actuation issues and cant move the damn truck.

    Are the rods supposed to be dead straight or slightly bent? I've never noticed. Mine now contacts the cab and has alot of play. I'm trying to isolate the cause of this as the old cab mounts were rotted and the cab had a list, the new mounts set the cab up much differently. The middle mounts need to be shimmed approx 1" :(

    If theyre not straight (the rods) a pic would be very much appreciated. Very close to saying 'f%$^ it' and fabbing a hydro set up.

    Thanks guys


Share This Page