52 in converson

[sandypants]

ok i took your advice and got the 52's now i need to attach them, should i do it like the tech artical? or should i do it another way ie mounts made by somebody? also going for the shackle flip in the back did the athome way just to see how i might like it and i think it is the way to go. any sugestions for who to get the mounts from and any pointers to this swap? thanx again sandypants

 

[rdn2blazer]

DIY has 52 mounts. thats your best bet.

 

[redneckdude]

DIY has 52 mounts. thats your best bet.

thats the route i went. could not be happier!

 

[Hogback Fabrication]

I moved the stock mounts in the front but I hate paying for parts when I can make/modify them.


For the rear:
I think a shackle flip is the way to go, ORD and diy4x make good shackle flip kits though I'm sure there are others.

 

[MTMike]

I did mine per the article (Before DIY released his B52s). I would say use DIY's setup because it will be a whole lot easier. Except the front mounts though, you should follow the tech article as close as possible for the rest of the install.

And I couldn't be happier with my DIY rear shackle flip kit!

Good luck!

 

[sandypants]

so will the 52's move it forward 2 inches, as in i need a new front drive shaft? or can i use the zero rate sprinds to move it back? or the b52's to move it back thanx everybody

 

[RGV72BLAZER]

if you want to save some $, use the Sky Mfg. front hanger. But if you want more bling and more options in case you're mistake prone, get the DIY stuff.

 

[NV_K5]

Go with the DIY flips. I went with some from ORD and a friend at the same time went with DIY just to compare; His are much beefier.