6.2 swap question

[steve_kibbe]

Putting a 6.2 from a 2wd auto sub in my truck.
The crank shaft on my old motor has a bushing for the 465 input shaft, but the "new" motor doesn't.

What do I need to do to make this work?

Can I buy a bushing and press/hammer it in?

I'm just about ready to drop it in, but am looking for answers..........

Thanks,

Steve

 

[tRustyK5]

The 6.2 uses a pilot bearing, so i installed a new pilot bearing. It's just a press in deal, but if you use the bearing make sure to pack a little grease in there.

Rene