700R4 to 203 spacer: FOUND

[RGV72BLAZER]

2" spacer for 700R4/203

 

[uglytruk]

Hmmm... I want this... I think.

I'm Having a 700R4 rebuilt, and have a 203 TC with a 27 spline output hub. Is this what I need? Ug

 

[RGV72BLAZER]

along with the th350/203 adaptor.

 

[uglytruk]

The TH350 203 adapter is 1" thick... Here's one. Is this what I need ta install the 700R4 to my rebuilt 203?

pix TH350 203

 

[uglytruk]

Here's the 700R4 208. I wanna' install the same spline 203... on my 700 to have Full Time 4wd. I'll still have locking hubs, just my fr driveshaft will always spin...

 

[RGV72BLAZER]

350/203 adaptor+spacer


700/208 adaptor redrill & tap the pattern

 

[uglytruk]

Your answer is a little too short fer me...

 

[4X4HIGH]

Your answer is a little too short fer me...

What he said was that you need a TH350/203 adapter and the 2" spacer OR you use your existing adapter and drill that bolt pattern onto the face of your 203 and then plug all unused holes.

 

[uglytruk]

So there's an adapter, and 2" spacer?
What's the 1" spacer from my TH350 203? Hmmm... I guess I needa 2" spacer. I really don't feel like drilling and tapping... Lazy...

 

[uglytruk]

Having trouble with pix... try again...

Nope, box says "done" but it's empty. tried several times... HELP?

 

[4X4HIGH]

So there's an adapter, and 2" spacer?
What's the 1" spacer from my TH350 203? Hmmm... I guess I needa 2" spacer. I really don't feel like drilling and tapping... Lazy...

That is your factory tranny to t-case adapter that must be used if you go the route of the 2" spacer along with that adapter.

 

[uglytruk]

Got pix?

I've taken a few, and tried ta post, but problems. Always worked, maybe I'll try IE. Mozilla is usually good...

Still comin' up blank... Hmmm...

 

[uglytruk]

Nope...

Here's IE, it's sooooooo slowwwwwww....

No go, stuck in da ditch.... Problem at host???