Timotheus
Registered Member
Well I've been pouring over this site for a few month since me and my brother bought this blazer. Figured it was time to post and get the ball rolling. We found it on good ole craigslist for $1000 dollars semi-running. The guy we bought it from swapped in some 3/4 ton axles 10B/14B not sure of the gear ratio yet. It has a rear shackle flip and some mikes off-road lift springs up front. Its coated with herculiner on most if the exterior. It has a straight body, just more rusted.
We got it home and slapped a new Holley 670 it and it ran pretty good minus a stumble right off the line. Starter and fuel promptly went out... thank God you can rebuild these trucks from O'rielys haha. Im a former RX7 guy and all parts are special order from Japan! So far we have cut out the rusted floor pans and replaced them, trimmed the fenders (the rear ones are a little wider than normal just to get rid of rust). We are currently putting together the Edelbrock RPM power package, just gotta order one more cylinder head. Also got a good deal on some 39x15x16.5 baja belteds on weld wheels.





We got it home and slapped a new Holley 670 it and it ran pretty good minus a stumble right off the line. Starter and fuel promptly went out... thank God you can rebuild these trucks from O'rielys haha. Im a former RX7 guy and all parts are special order from Japan! So far we have cut out the rusted floor pans and replaced them, trimmed the fenders (the rear ones are a little wider than normal just to get rid of rust). We are currently putting together the Edelbrock RPM power package, just gotta order one more cylinder head. Also got a good deal on some 39x15x16.5 baja belteds on weld wheels.