mdk5jr
Registered Member
Up for sale- '80 K-20 Chevy pick-up. I'm selling this truck more for parts than the truck itself. This truck is about 80% done. I don't want to part it out, I just don't have the time, nor could I stand to take it apart.
Description:
'80 K-20 cut & shortened to 109" wheelbase
350 engine
400 Trans
205 T-case fix yoke
Dana 60- 14bolt FF 4:10's
ORD cross-over steering w/arb studs
ORD HD front upper shackle hanger kit
ORD front shackles
ORD Tuff country 6" front springs
ORD HD rear shackle flip 2
ORD HD rear shackles 4.5 in
ORD Tuff country 4" 56" rear springs
all bushings are greasable & polyeurothane
poly cab mounts & trans mounts
Pro comp brake lines
New, still in box warn hubs
Truck sits on 38's, about 1/4 tread
New dynomax headers
2 front drive shafts
1 rear drive shaft
I did weld in 16 ga floors in cab, it would not take much to finish truck. The truck has not left the shop since these parts were put on. I also have a spare 10 bolt to go with it (use the brakes off the 10B to make the 14B disc). There is no bed on the truck, but I do have it, it's missing the hood and one door. I only drove the truck a couple of miles before I took it apart, so all I can say is it did run and it ran pretty good. Some oil leaks. I'm sure I have missed some stuff, I have over $4500 in parts. I'll take $3500 OBO.This may seem like just another Chevy truck, but it's got all the parts needed to build a stout truck or finish this one. Located in Maryland, $3500 OBO.
Description:
'80 K-20 cut & shortened to 109" wheelbase
350 engine
400 Trans
205 T-case fix yoke
Dana 60- 14bolt FF 4:10's
ORD cross-over steering w/arb studs
ORD HD front upper shackle hanger kit
ORD front shackles
ORD Tuff country 6" front springs
ORD HD rear shackle flip 2
ORD HD rear shackles 4.5 in
ORD Tuff country 4" 56" rear springs
all bushings are greasable & polyeurothane
poly cab mounts & trans mounts
Pro comp brake lines
New, still in box warn hubs
Truck sits on 38's, about 1/4 tread
New dynomax headers
2 front drive shafts
1 rear drive shaft
I did weld in 16 ga floors in cab, it would not take much to finish truck. The truck has not left the shop since these parts were put on. I also have a spare 10 bolt to go with it (use the brakes off the 10B to make the 14B disc). There is no bed on the truck, but I do have it, it's missing the hood and one door. I only drove the truck a couple of miles before I took it apart, so all I can say is it did run and it ran pretty good. Some oil leaks. I'm sure I have missed some stuff, I have over $4500 in parts. I'll take $3500 OBO.This may seem like just another Chevy truck, but it's got all the parts needed to build a stout truck or finish this one. Located in Maryland, $3500 OBO.
