87 rear drive shaft with 1310x1350 ujoint

[Mkuhn138]

Upgraded to 1 tons, so selling my rear shaft. It was built by Banning Driveline out of Banning, CA (for the previous owner). It's setup for 6" of lift. It has a brand new 1310x1350 conversion U-joint I just put on it. It has a slip yoke for a 32 spline output shaft. Has a fresh coat of paint with a few scuffs. Asking $95 OBO, plus shipping.

 

[wage92]

sorry i am not good with the ujoint styles yet, what rear axle is this meant to fit?

 

[Mkuhn138]

14 bolt

 

[xenomarine]

For others' reference, it seems to be a conversion u joint, so it could be swapped to damn near anything for any axle.

 

[Mkuhn138]

Exactly... Anything with a 1350 yoke

 

[eel757]

will it fit a 208?

 

[Mkuhn138]

Yes, but it sold. Sorry