CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

OK 89 Jimmy 350 sm465

Thomas Young

I miss the smell of 2 stroke in the morning!
Joined
Feb 28, 2016
Posts
43
Reaction score
53
Location
Oklahoma
I'm thinking about selling my jimmy

I have replaced the rusted out panels with fresh steel and primered it with 2part epoxy
factory part
tbi350, sm465, np241, 3.42 open diffs
electric windows upfront
Cruise control
Tilt steering

after market
4" tough country lift
DIY4X shackle flip
5 New Falken wildpeak at3 35"
Custom rear bumper/air tank with swinging tire carrier with ammo can
Manual rear window
bed linered campershell
New dash
sound deadener on floor
New rubber floor
On board air (York 210) with auto pressure switch and gauge

The bad
It typically smokes quite a bit at Idle
#5 cylinder is eating oil roughly 2-3 quarts per tank (27gal.) of fuel as well as fouling the spark plug
all other cylinder had a clean plugs.

Tailgate doesn't seal at the campershell on the drivers side corner which sometimes allows rain to get in.

Cruise control works but the vacuum servo leaks and it causes it to be jerky and annoying.

Windshield wiper control board doesn't shut off unless the switch is rolled backwards.

A/C is complete but doesn't have Freon and I have never messed with it. Heater works great.

Electric windows work but need help, passenger switch doesn't always work.

Rear ujoint doesn't like the lift and its a bastard ujoint because Previous owner put a one ton drive shaft
in it.

I'm not going to put my phone in the add so just private message me for it. I don't need any trades just looking for 4500 obo

I also have an extra campershell and sliding glass that are free if you want them.

20161124_162355.jpg

20170318_141225.jpg

20170219_170046.jpg

20170603_154938.jpg
 
I have swapped another engine into it. The engine has 120k on and runs good.
New parts at engine swap.
Clutch
throw out bearing
pilot bushing
flywheel resurfaced
rear main seal
oil pan gasket
water pump and thermostat
both exhaust manifolds

It has a fresh coat of primer

Im droping the price 5500 firm
 
Last edited:
I have lowered the price to 5500 firm. I hope someone on here buys it, instead of a random kid from craigslist.

Has a new ac compressor (ac delco), new dryer and condensor. Ac works pretty good for what it is.
 
I have swapped another engine into it. The engine has 120k on and runs good.
New parts at engine swap.
Clutch
throw out bearing
pilot bushing
flywheel resurfaced
rear main seal
oil pan gasket
water pump and thermostat
both exhaust manifolds

It has a fresh coat of primer

Im droping the price 5500 firm
What brand rear bumper us that?
 
GLWS, it looks pretty good. I keep eyeballing it on craigslist. Im looking at blazers but no money right now.
 

Latest Posts

Top Bottom