"Alaskan Ingenuity"

[rencher2]

 

[Drey]

That has a striking resemblece to a mobile trebuche

 

[rencher2]

Only When The Neighbors P$$$ me off!

 

[chevyfumes]

I like it...

 

[darkshadow]

he must have moved north...

 

[rencher2]

 

[BKinzey]

Now that I've read both threads on this I'll have to say the workmanship looks good but the engineering is what I'd question. Just looks a little funky to me.

 

[rencher2]

It Probably looks funky because it's built with a Chassis!

 

[chevyfumes]

Sometimes you work with what you have, end of story.
It looks good to me, so if you had to crawl under it and it was on cinder blocks I may ? that....

 

[BKinzey]

It Probably looks funky because it's built with a Chassis!

Nope. Looks like it could use some triangleation. There's a high center of gravity. If it works for you and since you know what you will use it on then it's probably fine.

 

[rencher2]

Forward Gussets Would Block the 5' reach, But Rear Are In The Works. I Don't get under anything without blocks(railroad ties). Saw A lowrider kid get sqaushed @ age 14.

 

[bigbluesuburban]

My only question is what happened to rencher1????

 

[Confedneck79K30]

he died in an unfortunate home built cherry picker accident... LMAO

 

[rencher2]

BEEN busy building ,while you've just been yappin. get a project beer gut!

 

[Confedneck79K30]

got a project, AND a fulltime job, sorry i dont spend time boinkin malamutes to waste my spare time... get back to it, 'beer gut'

 

[rencher2]

Pawn. Apparently, you don't travel. Check! Stay Out Negativity!

 

[TexasBlazerBoy]

Nice paint job...is that factory

 

[rencher2]

That's get it done before it rains.

 

[kyser_soze]

I like it.

If you would like some friendly advice, I would add a gusset to the hoisting bar itself before it snaps like a toothpick at the fulcrum.

 

[rencher2]

you are right , Im planning on welding a 3/8"x 4" Flatbar the full length atop the bar. Also chain from the verticals to the rear. Thank you for the positive advice.