CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Any interest in D60 DRW front hubs?
- Thread starter 76zimmer
- Start date
hidesertwheelin
1/2 ton status
How much and you you think they will fit in a USPS priority one rate box? 
I will check on the shipping box...they measure 13 diameter by about 10 long (wide)
the thickness of the rotors is 1.520 or more, and minimum thickness says 1.465.
The inner hubs have a good grease coating in them, so no corrosion in there, the rest of them have been run through the mud, so they could use a cleaning.
These came off my D60, that was under a junkyard wrecker.
How bout 50$ plus the trip?
the thickness of the rotors is 1.520 or more, and minimum thickness says 1.465.
The inner hubs have a good grease coating in them, so no corrosion in there, the rest of them have been run through the mud, so they could use a cleaning.
These came off my D60, that was under a junkyard wrecker.
How bout 50$ plus the trip?
hidesertwheelin
1/2 ton status
I'm an idiot, I read SRW hubs.
srw or drw wont fit in flat rate box 
K5dreamer
1/2 ton status
obviously im a fan of the H1 beadlocks.... so id hate to see those go to the scrap yard 
try pirate4x4 thay grab them and cut them to srw a lot for trail only rigs.
