I'm getting a Dana 60 rear out of a 68 Road Runner, has 3.55s in it now, and 4.10 too. Has the Suregrip, Moroso billet ujoint caps, new brake stuff on it, etc. 100% complete axle. I think it's 35 spline already, perfect width for my S-10 @ 60" wide. It has the small bolt pattern, and doesn't look like there is enough room to redrill to at least 5x5.5 (big Ford/Dodge pattern). Being this is a rare bird, how much is axles for this thing? Thought about some adaptors, but that will make it wider, something I don't want to do...
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Any Mopar guys here?
- Thread starter b454rat
- Start date
pauly383
Daddy383
Just read that. I guess $315 isn't too bad for new shafts. Any cheaper places??
wayne
3/4 ton status
If it is a factory B Body D60 I would sell it and just get a truck 60 and cut it down.
Thought about that too. Buddy told me about it, Ithink he knows what it's worth. He had it years ago, wanted to buy it back to sell. Gonna talk to a builder today and see what it would cost to shorten one. Knowing him, 3 times what I paid for this one.....
Got the axle the other day, and found the BOM and the P/L numbers. BOM says it's 69.5-72 B body, has 35 splines. All the dates are close, ring gear is 7-24-69, PL is 9-15-69, and the axle tube is 9-22-69. Gonna clean it up and put it on Evilbay, if I decide not to use it. Would look sweet under my S-10 Blazer....
pauly383
Daddy383
I would assume some Mopar nut scoops it up so you can buy a nice truck axle 
wouldn't you know , ones up to 1300 so far clicky
wouldn't you know , ones up to 1300 so far clicky
Sell that thing on eBay. Those go for pretty pennies there.
Need to take some pics of it before it goes on Evilbay, I think that would be the best way to sell it. Tried a Mopar guy, but he never emailed me back, screw him.
Be careful running those Moroso u-joint caps. They seriously limit the angle the u-joint can operate at before binding.
Cars have MUCH lower u-joint operating angles than lifted 4x4's
Cars have MUCH lower u-joint operating angles than lifted 4x4's
pauly383
Daddy383
That one listing I saw on ebay today was over 1300 bucks a couple hours ago , SELL YOURSb454rat said:
If I do run it, it won't have those on it....
