Are these SBC headers?!

[handloader90]

Never seen the ports on the flange like this...

Got em for the cheap.

All of the ports are shaped like that, not just the center ones.

 

[Bent77]

Look like Chrysler small block

 

[handloader90]

Fawking Jeep/AMC V8 headers...

P/N: 99200 is stamped on the flange.

Pulling up as a Hedman header for old V8 powered Wranglers.

If the bolt mounting pattern is the same as a SBC and the ports line up properly I could probably run them with a SBC gasket.

 

[Bent77]

Probably have seal issues for life

Cut em and sacrifice them to the Chevy gods

 

[handloader90]

Nevermind. Just measured the two middle mounting bolts on the headers, they're spaced 3.5" apart.

The manifolds on my engine are around 4" apart.

Guess they're going back on Craigslist lol.

 

[handloader90]

I should pick up a 55 gal. drum, turn it into a smoker and use these as the chimneys.

 

[Bent77]

I should pick up a 55 gal. drum, turn it into a smoker and use these as the chimneys.

Best use yet for Jeep parts

 

[handloader90]

I've got enough stock bracketry, leaf springs and other junk laying around. I'm sure I could come up with someone interesting lol.