balljoint ?

[cegusman]

I am doing my ball joints rights now, the problem is the lower ball joint nut spins with the bolt how do I get it off?

Houston, TX
<a target="_blank" href=http://community.webshots.com/user/cegusman>http://community.webshots.com/user/cegusman</a>

 

[**DONOTDELETE**]

If you're not using air with a good air gun then you might need to soak the heck out of it with some penetrating fluid

Later...

4 wheelin's not a job, it's an adventure!

 

[ftn96]

Take a floor jack and jack up on the bottom end of the Ball joint. This will help hold it in place while your turning the wrench on the nut!!!

**WARN**ing, Something winching this way comes!

<a target="_blank" href=http://www.mccords.s5.com/myk5/index.htm>NashvilleK5</a>

 

[Triaged]

I tried all the stuff that was said above and mine still didn't come out. I drilled 2 holes down thru the nut and than split it in 2 with a chisle. It didn't take long at all but I broke a bit because the nut span when I was drilling it.

'71 Blazer CST w/ a 400sbc, 4" lift, 36" Supper Swampers, and alot of rust
<a target="_blank" href=http://community.webshots.com/user/triaged>See it Here </a>