original balzer
1/2 ton status
Didnt do a damn thing all winter it just sat under 2.5 foot of snow. figured Id snap a few phone pics just to establish where its at right now.
This concerns me dont know why it never realy bothered me while building it. Not much that can be done though as it needs to be this low due to the way the frame gets bigger after the axle center line. To raise this I would have to figure out how to raise the rear spring eyes too.
rear spring eyes, prob gunna result in a bad shackle angle but there was a big hole here aready looked factory but the shackle hanger didnt fit had to open it up. then had to open it up a bit more cuz I went to the bigger version sold by ORD
beuty shot of the "good" side
Sorry the cell phone pics suck but yet again I have lost my digi, what you guys think?
This concerns me dont know why it never realy bothered me while building it. Not much that can be done though as it needs to be this low due to the way the frame gets bigger after the axle center line. To raise this I would have to figure out how to raise the rear spring eyes too.
rear spring eyes, prob gunna result in a bad shackle angle but there was a big hole here aready looked factory but the shackle hanger didnt fit had to open it up. then had to open it up a bit more cuz I went to the bigger version sold by ORD
beuty shot of the "good" side
Sorry the cell phone pics suck but yet again I have lost my digi, what you guys think?
